F 150 4WD V8-4.6L VIN 8 (2010)
9. Install the 2 generator bracket-to-coolant crossover bolts.
-
Tighten to 10 Nm (89 lb-in).
10. Attach the radio interference capacitor wiring harness retainer to the generator wiring harness.
11. Rotate the accessory drive belt tensioner clockwise and install the accessory drive belt on the generator pulley.
12. NOTE: 4WD shown, RWD similar.
Connect the brake booster vacuum hose to the vacuum tee.
13. Connect the heated PCV element electrical connector.
14. Install the PCV tube.
15. Install the fuel rail. For additional information, refer to Fuel Delivery and Air Induction.
16. Install the ACL outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.
17. Connect the battery ground cable. For additional information, refer to Battery.
18. Fill the cooling system.
