F 150 4WD V8-4.6L VIN 8 (2010)
4. Using the Slide Hammer and the Crankshaft Rear Seal Remover, remove the crankshaft rear seal.
-
Discard the crankshaft rear seal.
Installation
1. NOTE: Lubricate the inner lip of the crankshaft rear seal with clean engine oil.
Using the 2 Crankshaft Rear Seal Installers, install the crankshaft rear seal.
2. Using the 2 Crankshaft Rear Seal Installers and the Crankshaft Rear Oil Slinger Installer, install the crankshaft rear oil slinger.
3. Install the engine-to-transmission spacer plate.
4. Install the flexplate. For additional information, refer to Flexplate See: Transmission and Drivetrain/Flex Plate/Service and Repair/Removal and
Replacement.