F 150 4WD V8-4.6L VIN 8 (2010)
9. Once fuel system service is complete, position the EVAP purge valve into place and install the bracket bolt.
-
Tighten to 10 Nm (89 lb-in).
All engines
10. Once fuel system service is complete, connect the battery ground cable. For additional information, refer to Battery.
11. NOTE: It may take more than one key cycle to pressurize the fuel system.
Cycle the ignition key to the ON position and wait 3 seconds to pressurize the fuel system. Check for leaks before starting the engine.
