ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 9559 > < Initial Inspection and Diagnostic Overview|Page 9557
Page 20
background image

-

Is the voltage greater than 10 volts?

Yes

REPAIR circuit CAT14 (OG) for an open. TEST the system for normal operation.

No

VERIFY the BJB fuse 54 (5A) is OK. If OK, REPAIR circuit CBB54 (VT/OG) for an open. TEST the system for normal operation. If not OK, REFER
to the Wiring Diagrams to identify the possible causes of the circuit short.  See: Diagrams/Electrical Diagrams/Diagrams By Number

-------------------------------------------------
AD8 CHECK THE TRAILER BATTERY CHARGE VOLTAGE SUPPLY CIRCUIT FOR A SHORT TO VOLTAGE

 

-

Disconnect: Trailer Battery Charge Relay.

-

Measure the voltage between the trailer tow connector pin 5, circuit CAT14 (OG), component side and ground.

-

Is any voltage present?

Yes

REPAIR circuit CAT14 (OG) for a short to voltage. TEST the system for normal operation.

No

GO to AD9.

-------------------------------------------------
AD9 CHECK FOR VOLTAGE TO THE TRAILER BATTERY CHARGE RELAY COIL (BATTERY CHARGE ALWAYS ON)

Initial Inspection and Diagnostic Overview|Page 9559 > < Initial Inspection and Diagnostic Overview|Page 9557