F 150 4WD V8-4.6L VIN 8 (2010)
NOTE: If transmission is being repaired for a contamination-related failure, use a new transmission fluid filter and seal. The transmission fluid
filter may be reused if no excessive contamination is present.
Install a new transmission fluid filter and seal as required.
2. Position the pan magnet into the transmission fluid pan.
3. NOTE: The transmission fluid pan gasket is reusable. Clean and inspect for damage; if not damaged, the transmission fluid pan gasket should be
reused.
Install the transmission fluid pan and gasket.
1. Position the transmission fluid pan and gasket.
2. Install the transmission fluid pan bolts.
-
Tighten to 14 Nm (124 lb-in).
4. NOTE: When filling a dry transmission and converter, start with a minimum of 4.7L (5 qt).
Fill the transmission to the correct level, using approved transmission fluid.
-
Verify for correct operation.
-
Check for leaks.
Transmission Filter - In Line
Transmission Filter - In Line
Transmission fluid in-line filter - with an auxiliary transmission fluid cooler
NOTE: Use the following guidelines for installing the transmission fluid in-line filter:
-
If the transmission was overhauled and the vehicle was equipped with a transmission fluid in-line filter, install a new transmission fluid in-line
