F 150 4WD V8-4.6L VIN 8 (2010)
9. Remove the condenser inlet jumper line.
Vehicles built before 12/21/2009 with "F" as second Vehicle Identification Number (VIN) digit, or vehicles built after 1/11/2010 with "B" as
second VIN digit
10. Disconnect the A/C pressure transducer electrical connector.
11. Remove the condenser inlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
12. Remove the compressor-to-condenser discharge line.
All vehicles
13. To install, reverse the removal procedure.
-
Install new gasket seals and O-ring seals.
-
Add the correct amount of clean PAG oil to the refrigerant system. For additional information, refer to the Refrigerant Oil Adding procedure.
14. Evacuate, leak test and charge the refrigerant system.
