F 150 4WD V8-4.6L VIN 8 (2010)
Air Filter Element: Service and Repair
Air Cleaner Element
Air Cleaner Element
Removal and Installation
1. Loosen the clamp and detach the Air Cleaner (ACL) outlet pipe from the ACL cover.
-
To install, tighten to 4 Nm (35 lb-in).
2. Disconnect the Mass Air Flow (MAF) sensor electrical connector.
3. Release the retaining clamps and remove the ACL cover.
4. If servicing the ACL cover, remove the 2 screws and the MAF sensor.
-
To install, tighten to 2 Nm (18 lb-in).
5. Remove the ACL element.
6. NOTICE: The Air Cleaner (ACL) element must be fully seated into the ACL housing. Failure to do so will result in unusual engine noise.
To install, reverse the removal procedure.
