F 150 4WD V8-4.6L VIN 8 (2010)
Fuel Tank Pressure Sensor: Service and Repair
Fuel Tank Pressure Sensor
Fuel Tank Pressure Sensor
Removal and Installation
WARNING: Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in
serious personal injury.
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component.
Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
1. Remove the fuel tank. For additional information, refer to Fuel Delivery and Air Induction.
2. Disconnect the 2 Fuel Tank Pressure (FTP) sensor and vapor tube assembly-to-fuel tank vent valve quick connect couplings. For additional
information, refer to Fuel Delivery and Air Induction.
3. Disconnect the FTP sensor and vapor tube assembly-to-fuel pump module quick connect coupling. For additional information, refer to Fuel
Delivery and Air Induction.
4. Remove the FTP sensor and vapor tube assembly from the fuel tank.
5. To install, reverse the removal procedure.
-
Carry out the Evaporative Emission System Leak Test. For additional information, refer to Evaporative Emission System Leak Test See:
Emission Control Systems/Evaporative Emissions System/Testing and Inspection.
