F 150 4WD V8-4.6L VIN 8 (2010)
Fuel Level Sensor: Service and Repair
Fuel Level Sender
Fuel Level Sender
Removal and Installation
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component.
Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
1. Remove the Fuel Pump (FP) module. For additional information, refer to Fuel Pump Module See: Fuel Delivery and Air Induction/Fuel
Pump/Service and Repair/Fuel Pump Module.
2. Disconnect the fuel level sender-to-FP module electrical connector.
3. Disconnect the FP module retainer clip and slide the fuel level sender off of the FP module.
4. To install, reverse the removal procedure.
