F 150 4WD V8-4.6L VIN 8 (2010)
Oxygen Sensor: Service and Repair
Heated Oxygen Sensor (HO2S)
Heated Oxygen Sensor (HO2S)
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. NOTE: If necessary, lubricate the Heated Oxygen Sensor (HO2S) with penetrating and lock lubricant to assist in removal.
Using the Exhaust Gas Oxygen Sensor Socket, remove the HO2S.
-
Calculate the correct torque wrench setting for the following torque.
-
To install, tighten to 46 Nm (34 lb-ft).
3. To install, reverse the removal procedure.
-
Apply anti-seize to the threads of the HO2S.