F 150 4WD V8-4.6L VIN 8 (2010)
5. Remove the quick connect coupling from the tube.
Connect - Type I
1. NOTE: Apply clean engine oil to the O-ring seals.
Install the quick connect coupling onto the tube until completely seated.
2. NOTICE: Do not use any tools. The use of tools may cause a deformity in the clip components which may cause fuel leaks.
NOTE: Make sure the coupling is completely seated and locked onto the tube by pulling on the quick connect coupling.
Apply the secondary latch into the locked position.
3. Connect the battery ground cable. For additional information, refer to Battery.
Disconnect - Type II
WARNING: Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in
serious personal injury.
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component.
Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent
accidental spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this
instruction may result in serious personal injury.
WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in
serious personal injury.
