F 150 4WD V8-4.6L VIN 8 (2010)
7. NOTICE: The Fuel Pump (FP) module must be handled carefully to avoid damage to the float arm and the filter.
NOTE: If the FP does not clear the FP mounting flange on the fuel tank, the use of a screwdriver may be necessary.
Remove the FP module.
-
If necessary, insert a screwdriver into the empty FP rod hole and slightly pull the screwdriver inboard until the base of the FP clears the FP
mounting flange.
8. Remove and discard the FP module O-ring seal.
9. To install, reverse the removal procedure.
-
Install a new FP module O-ring seal and lubricate with clean engine oil.
