F 150 4WD V8-4.6L VIN 8 (2010)
-
To install, tighten to 25 Nm (18 lb-ft).
4. Disconnect the CKP sensor electrical connector.
5. Remove the bolt and the CKP sensor.
-
To install, tighten to 10 Nm (89 lb-in).
6. To install, reverse the removal procedure.
-
Lubricate the O-ring seal with clean engine oil prior to installation.
7. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
