F 150 4WD V8-4.6L VIN 8 (2010)
NOTICE: New shift motor bracket nuts are loose and are tightened last. Failure to follow the steps in the correct order may result in damage
to the component.
2. Install the transfer case shift motor and the 3 bolts.
-
Tighten to 10 Nm (89 lb-in).
3. Install the transfer case shift motor bracket bolt.
-
Tighten to 10 Nm (89 lb-in).
4. Secure the transfer case shift motor bracket nuts.
-
Tighten to 3 Nm (27 lb-in).
5. NOTE: After the wire is inserted into the connector, gently pull the wire back to verify the pin is locked inside the connector.
Insert the coil wire pin in the electrical connector and install the inner connector retainer.
