F 150 4WD V8-4.6L VIN 8 (2010)
Parking Assist Control Module: Service and Repair
Parking Aid Module (PAM)
Removal and Installation
1. NOTE: Module configuration is required when a new Parking Aid Module (PAM) is being installed.
Upload the PAM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in
Information Bus. See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and
Relearning
2. Disconnect the PAM electrical connector.
3. Remove the 2 PAM nuts.
4. Remove the PAM.
5. To install, reverse the removal procedure.
-
Download the configuration information to the PAM. For additional information, refer to PMI in Information Bus. See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning