F 150 4WD V8-4.6L VIN 8 (2010)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
NOTICE: Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these
charges.
1. NOTE: This step is necessary only if a new ABS module is being installed.
Connect the scan tool and upload the module configuration information from the ABS module.
2. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.
3. Disconnect the ABS module electrical connector.
4. Remove the 4 screws and the ABS module.
-
To install, tighten to 3 Nm (27 lb-in).
5. To install, reverse the removal procedure.
-
When installing a new ABS module, it must be configured (using vehicle as-built data or module configuration information retrieved earlier in
this procedure). For additional information on configuration, refer to Programmable Module Installation (PMI) in Information Bus. See:
Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
