F 150 4WD V8-4.6L VIN 8 (2010)
systems increases the risk of serious personal injury or death in a crash.
1. Remove the 5 pin-type retainers and sound insulator.
2. Remove the tower cover bezel.
-
Pry up on the front, middle portion of the nut cover and remove.
-
Remove the nut.
-
Remove the tower cover bezel.
3. Remove the 2 bolts and turning loop.
-
To install, tighten to 40 Nm (30 lb-ft).
4. Release the safety belt tongue from the detachable safety belt anchor.
-
Insert an appropriate tool into the detachable safety belt anchor and release the safety belt.
5. Remove the bolt and safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
6. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
7. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in Safety
Belt System See: Testing and Inspection/Component Tests and General Diagnostics.
