F 150 4WD V8-4.6L VIN 8 (2010)
Ignition Switch Lock Cylinder: Service and Repair
Ignition Lock Cylinder - Functional
Ignition Lock Cylinder - Functional
Removal and Installation
NOTE: When a new lock cylinder is installed, the tailgate lock cylinder, door lock cylinders and the ignition lock cylinder should be installed as a set.
This eliminates carrying an extra key which fits only 1 lock. If a new key is to be used, the new key code is attached to a tag.
NOTE: The individual door lock cylinders are repaired by discarding the inoperative lock cylinder and building a new lock cylinder using the
appropriate lock repair package. The lock repair package includes a detailed instruction sheet to build a new lock cylinder to the current key code of the
vehicle.
1. Remove the Passive Anti-Theft System (PATS) transceiver. For additional information, refer to Antitheft and Alarm Systems.
2. With the ignition switch in the ACC position, press the locking pin with a suitable tool and remove the lock cylinder.
3. If a new lock cylinder with keys is replaced, the new PATS keys must be programmed. For additional information, refer to Key Programming
Using Diagnostic Equipment in Antitheft and Alarm Systems. See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and
Inspection/Programming and Relearning/Key Programming Using Diagnostic Equipment
4. To install, reverse the removal procedure.