F 150 4WD V8-4.6L VIN 8 (2010)
6. NOTICE: Tightening one bolt before tightening the other may cause the sensor to bind or become damaged.
Tighten the TR sensor bolts and remove the TR Sensor Alignment Gauge.
-
Tighten to 9 Nm (80 lb-in).
7. Install the manual control lever.
1. Position the manual control lever.
2. Install a new manual control lever shaft outer nut.
-
Tighten to 33 Nm (24 lb-ft).
8. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever
cable end is snapped onto the manual control lever ball stud. Press the selector lever cable into the selector lever cable bracket and listen for the
cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket. Also make sure that
the selector lever cable end is correctly installed onto the manual control lever ball stud. Pull back on the selector lever cable end to make sure that
the selector lever cable end is correctly installed.
Connect the selector lever cable end to the manual control lever with the lever in the (D) position.
9. Lower the vehicle.
