F 150 4WD V8-4.6L VIN 8 (2010)
NOTE: The remaining removal step(s) are only necessary when transferring the original sliding glass panel to the new rear sliding window assembly.
Power or manual sliding rear window
14. Remove the sliding rear window glass. For additional information, refer to Window Glass - Rear, Power Sliding Panel See: Window Glass - Rear,
Power Sliding Panel or Window Glass - Rear, Manual Sliding Panel See: Window Glass - Rear, Manual Sliding Panel.
15. Remove the upper and lower rail fillers from the new rear window glass frame assembly.
Power sliding rear window
16. Slide the center bracket guide all the way to the LH side, then pull the LH side straight up so the guide foot can pass through the slot in the glass
frame assembly.
17. Carefully slide the center bracket guide all the way to the RH side, then pull the RH side straight up so the guide foot can pass through the slot in
the glass frame assembly. Transfer the center bracket guide to the new rear glass assembly.
Power or manual sliding rear window
18. Transfer the original sliding rear window glass to the new rear glass assembly. For additional information, refer to Window Glass - Rear, Power
Sliding Panel See: Window Glass - Rear, Power Sliding Panel or Window Glass - Rear, Manual Sliding Panel See: Window Glass - Rear,
Manual Sliding Panel.
Installation
All vehicles
1. NOTE: Remove as much of the foam core butyl as possible from the body and window glass prior to installation.
Apply foam core butyl to the window. Overlap the foam core butyl by 25 mm (1 in) at the bottom middle of the rear window glass.
Power sliding rear window
2. NOTICE: The following substeps are to prevent the cables from popping out of the motor housing. If an existing regulator and motor
assembly is to be reused, do not allow the cables to pop out of the motor housing, as they can unwind from the drum. If the cables unwind
from the drum, a new regulator and motor assembly will have to be installed.
NOTE: The aid of an assistant will be required to support the glass in close proximity to the body opening during the following power sliding rear
window installation steps.
