F 150 4WD V8-5.4L Flex Fuel (2008)
Memory Positioning Module: Service and Repair
DRIVER SEAT MODULE (DSM)
Removal and Installation
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE: Prior to the removal of the module, it is necessary to upload the module configuration information to a scan tool. This information must be
downloaded into the new driver seat module (DSM) after installation.
1. Remove the driver seat.
2. Remove the 2 screws.
-
To install, tighten to 7 Nm (62 lb-in).
3. Disconnect the 4 electrical connectors and remove the DSM.
4. NOTE: Once the module is installed it is necessary to download the module configuration information from the scan tool into the new module.
To install, reverse the removal procedure.
