F 150 4WD V8-5.4L Flex Fuel (2008)
Part 2
Removal and Installation
1. Remove the front door trim panel.
2. Position the watershield aside.
3. If equipped, disconnect the actuating rod from the door lock cylinder.
4. Open the clip and disconnect the exterior front door handle actuating rod from the front door latch.
5. Remove the 3 front door latch bolts.
-
To install, tighten to 12 Nm (106 lb-in).
6. Release the interior front door handle actuating cable locator.
7. Disconnect the front door latch electrical connectors.
8. Remove the front door latch.
9. To install, reverse the removal procedure.
-
Lubricate the front door latch after installation.
