F 150 4WD V8-5.4L Flex Fuel (2008)
15. If equipped, disconnect the 3 memory seat position sensor electrical connectors (one shown) and detach the wiring harness from the cushion frame.
16. Remove the 4 nuts and cushion frame.
-
To install, tighten to 25 Nm (18 lb-ft).
-
Disconnect and detach any remaining electrical connectors and wire harness attached to the seat cushion frame.
17. Remove the 2 screws and lumbar adjuster.
18. NOTE:
-
The lumbar assembly should be fully relaxed before cable disconnection.
-
Note cable routing for installation.
Detach the lumbar cable from the lumbar adjuster and route through the seat.
