F 150 4WD V8-5.4L Flex Fuel (2008)
Front Seat Backrest - 20 Percent, Without Storage (Part 2)
Disassembly and Assembly
NOTE: Due to locator pin location on the riser frame, 20 percent seat riser frames will not interchange between regular cab vehicles and
SuperCab/SuperCrew vehicles.
All seats
1. Remove the 20 percent seat.
2. Remove the LH side shield pin-type retainer, screw and shield.
3. Remove the RH upper side shield screw and shield.
4. Remove the RH lower side shield screw and shield.
Seats with storage armrest
5. Remove the cupholder assembly screws.
-
Disconnect the electrical connector and remove the cupholder assembly.
All seats
6. Remove the safety belt buckle bolt or safety belt mini-buckle bolt and buckle/mini-buckle on the LH side.
-
To install, tighten to 55 Nm (41 lb-ft).
7. Remove the safety belt bolt or safety belt buckle bolt and safety belt/buckle on the RH side.
-
To install, tighten to 55 Nm (41 lb-ft).
8. Remove the LH backrest bracket pivot bolt and pivot bolt bushing.
-
To install, tighten to 35 Nm (26 lb-ft).
Seats with storage armrest
9. Remove the backrest stop bolt.
All seats
10. Remove the 2 RH upper adjustable backrest bracket bolts and the adjustable backrest.
-
To install, tighten to 35 Nm (26 lb-ft).
11. Remove the RH lower adjustable backrest bracket screw, 2 bolts and the adjustable backrest bracket.
12. Remove the LH lower backrest pivot bracket screw, 2 bolts and the backrest pivot bracket.
Seats without storage armrest
13. Unzip the armrest trim cover zipper, peal the trim cover back and remove the hog rings and the trim cover.
All seats
14. To assemble, reverse the disassembly procedure.
Seat Backrest - Rear
SEAT BACKREST - REAR
