F 150 4WD V8-5.4L Flex Fuel (2008)
Front Seat Cushion - Passenger (Part 2)
Special Tool(s)
Special Tool(s)
Removal and Installation
WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to
follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which
increases the risk of serious personal injury or death.
CAUTION: It is necessary to carry out the occupant classification sensor (OCS) system reset when a front passenger seat cushion is
disassembled, a new trim cover is installed or an OCS system service kit is installed. A scan tool is used to carry out the OCS system reset
command. Failure to follow this instruction may result in system failure and the incorrect operation of the OCS system.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
LH shown, RH similar.
All seats
1. Remove the front seat.
2. Remove the front seat backrest.
3. Push the 2 release tabs and remove the head restraint.
