F 150 4WD V8-5.4L Flex Fuel (2008)
Front Seat Cushion - Passenger (Part 2)
Special Tool(s)
Special Tool(s)
Removal and Installation
WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to
follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which
increases the risk of serious personal injury or death.
CAUTION:
-
It is necessary to carry out the occupant classification sensor (OCS) system reset when a front passenger seat cushion is disassembled, a
new trim cover is installed or an OCS system service kit is installed. A scan tool is used to carry out the OCS system reset command.
Failure to follow this instruction may result in system failure and the incorrect operation of the OCS system.
-
Do not install a new heater mat on a front passenger seat cushion. If a new cushion heater mat is needed on the front passenger seat, an
occupant classification sensor (OCS) system service kit equipped with a heater mat must be installed. Failure to follow this instruction
may result in incorrect operation of the OCS system.
NOTE:
-
Occupant classification sensor (OCS) system components (seat wiring harness, seat cushion frame, seat cushion foam pad, bladder with pressure
sensor and occupant classification system module [OCSM]) are calibrated to each other and are serviced as an assembly. The OCS system
components are not to be installed separately. If a new OCS system, OCS system component or seat cushion foam pad are needed, an OCS system
service kit (seat cushion frame, seat cushion foam pad, bladder with pressure sensor, seat wiring harness and OCSM) must be installed as an
assembly.
-
To identify between a production OCS system and a OCS system service kit, inspect the OCSM electrical connector.
A production OCS system allows the disconnection of the OCSM electrical connector.
