F 150 4WD V8-5.4L Flex Fuel (2008)
Wheel Speed Sensor: Service and Repair
Front
Wheel Speed Sensor - Front, Four Wheel Drive (4WD)
Wheel Speed Sensor - Front, Four Wheel Drive (4WD)
Removal and Installation
1. Remove the wheel and tire.
2. NOTE: The harness connector is located in the engine compartment secured to the fender apron.
Disconnect the wheel speed sensor electrical connector.
3. Disconnect the 2 wheel speed sensor harness retainers from the brake hose.
4. Remove the wheel speed sensor harness from the pushpin retainer.
5. CAUTION: Do not allow the brake caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
Remove the 2 brake caliper anchor plate bolts and position the brake caliper and anchor plate assembly aside.
^
Support the brake caliper anchor plate assembly using mechanic's wire.
^
To install, tighten to 112 Nm (83 lb-ft).
