F 150 4WD V8-5.4L Flex Fuel (2008)
Disc Brake System - Exploded View (Part 2)
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
WARNING: Always install new brake shoes or pads at both ends of an axle to reduce the possibility of brakes pulling vehicle to one side.
Failure to follow this instruction may result in uneven braking and serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Check the brake fluid level in the brake master cylinder reservoir.
^
If necessary, remove fluid until the brake master cylinder reservoir is half full.
2. Remove the wheel and tire.
3. CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.
Remove the 2 brake caliper guide pin bolts and position the caliper aside.
^
Support the caliper using mechanic's wire.
4. Remove the brake pads and the 2 spring clips.
5. Inspect the brake pads for wear and contamination.
Installation
1. NOTE: One brake disc pad kit contains the pads required for both the RH and LH side.
Install the new spring clips and brake pads.
2. NOTE: Protect the pistons and boots when compressing the piston into its bore.
Using a suitable tool, compress the disc brake caliper pistons into the brake caliper bore.
3. NOTE: Tighten the lower caliper guide pin bolt first.
Position the brake caliper on the brake caliper anchor plate and install the 2 guide pin bolts.
^
Tighten to 74 Nm (55 lb-ft).
4. Install the wheel and tire.
^
Apply brakes several times to verify correct brake operation.
Rear
Brake Pads
