F 150 4WD V8-5.4L Flex Fuel (2008)
Brake Master Cylinder: Service and Repair
Removal and Installation
Brake Master Cylinder
Material
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Using a suitable suction device, drain the brake fluid reservoir.
2. Disconnect the brake fluid level switch electrical connector.
3. NOTE: Cap the brake tubes and plug the master cylinder ports.
Disconnect the 2 brake tubes from the master cylinder.
^
To install, tighten to 17 Nm (13 lb-ft).
4. Remove the 2 master cylinder nuts.
^
To install, tighten to 25 Nm (18 lb-ft).
5. To install, reverse the removal procedure.
^
Bleed the brake system.
