F 150 4WD V8-5.4L Flex Fuel (2008)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Anti-Lock Brake System (ABS) Module
Removal and Installation
CAUTION: Electronic modules are sensitive to electrical charges. The anti-lock brake system (ABS) module can be damaged if exposed to
these charges.
CAUTION: When installing a new anti-lock brake system (ABS) module or hydraulic control unit (HCU), do not use the pump motor
harness as a carrying handle. Failure to follow these instructions may result in damage to the HCU assembly.
All vehicles
1. Disconnect the battery ground cable. For additional information, refer to Battery.
Vehicles equipped with 5.4L engine
2. Remove the air cleaner intake pipe. For additional information, refer to Fuel Delivery and Air Induction.
All vehicles
3. Disconnect the ABS module electrical connector.
4. Remove the 4 screws and the ABS module.
^
To install, tighten to 3 Nm (27 lb-in).
5. NOTE: The ABS module is not repairable. If an internal problem exists, a new part must be installed.
