ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

A/C - Compressor Shuts OFF in High Temperatures|Page 2369 > < Thermostat, Engine Cooling|Specifications|Page 2359
Page 1
background image

Drive Pulley: Customer Interest
A/C - Compressor Shuts OFF in High Temperatures

TSB 07-24-7

12/10/07

A/C COMPRESSOR SHUTOFF - HIGH AMBIENT TEMPERATURES - VEHICLE STATIONARY IN GEAR

FORD:
2007-2008 F-150, F-150

LINCOLN:
2007-2008 Mark LT

ISSUE
Some 2007-2008 Mark LT and F-150 vehicles equipped with 5.4L or 4.6L engine only, may exhibit a loss of A/C compressor operation in ambient
temperatures greater than 110 °F (43 °C), when the vehicle is stationary for periods longer than 15 minutes, with the transmission in gear. Idling in gear
and extreme ambient temperatures may cause the vehicle control systems to disable A/C compressor operation.

ACTION
Follow the Service Procedure steps to replace the A/C compressor pulley and coolant pump pulley.

SERVICE PROCEDURE

NOTE

THIS TSB IS INTENDED TO RESTORE A/C COMPRESSOR OPERATION IN EXTREME HIGH AMBIENT TEMPERATURES WHEN THE
TRANSMISSION IS PLACED IN THE PARK POSITION. DO NOT ATTEMPT TO ADDRESS CUSTOMER CONCERNS OF GENERAL A/C
TEMPERATURE OUTPUT PERFORMANCE WITH THIS TSB. THIS TSB WILL NOT IMPROVE A/C SYSTEM DUCT TEMPERATURE
OUTPUT PERFORMANCE.

NOTE

DURING EXTREME HIGH AMBIENT TEMPERATURES WHEN IDLING STATIONARY FOR EXTENDED PERIODS OF TIME IN GEAR,
IT IS RECOMMENDED TO OPERATE THE A/C IN THE MAX POSITION, REDUCE BLOWER FAN SPEED FROM THE HIGHEST
SETTING, AND PUT THE TRANSMISSION INTO THE PARK POSITION TO CONTINUE TO RECEIVE COOL AIR FROM THE A/C
SYSTEM.

1.

Replace the A/C compressor pulley. Follow Workshop Manual (WSM), Section 412-01 for removal and installation details.

2.

Replace the coolant pump pulley. Follow WSM, Section 303-03 for removal and installation details.

3.

Drain approximately 1 quart of coolant from the cooling system into a clean container which will permit reuse of coolant in the vehicle. Refer to
WSM, Section 303-03.

4.

Replace the clamp on the heater core feed hose, near the right hand front of engine, at the water pump outlet pipe connection point.

5.

Refill the cooling system.

WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage 
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.

OPERATION

DESCRIPTION

TIME

072407A

2007-2008 F-150 4X2,

1.7 Hrs.

5.4L and 4.6L Engines,
2007-2008 Mark LT 4X2.
Replace A/C Compressor
Pulley, Coolant Pump
Pulley and Heater Feed
Hose Clamp at Coolant
Pump Outlet. Includes
lime Remove and Install
A/C Compressor and to
Drain and Fill Cooling
system.(Do Not Use With
19700A, 19700A4,

A/C - Compressor Shuts OFF in High Temperatures|Page 2369 > < Thermostat, Engine Cooling|Specifications|Page 2359