F 150 4WD V8-5.4L Flex Fuel (2008)
4. Install the battery cover.
5. Position the engine harness and attach the retainer.
6. Connect the VCT solenoid electrical connector.
7. If equipped, connect the vacuum tube.
8. Position the crankcase ventilation tube and connect the quick connect couplings.
9. Using new O-rings, connect the evaporator inlet tube fitting.
10. Install the suction accumulator-to-A/C compressor manifold tube stud.
^
Tighten to 8 Nm (71 lb-in).
11. Lubricate the new A/C compressor manifold tube O-ring seals with refrigerant compressor oil. Position the A/C compressor manifold tube and
install the nut.
^
Tighten to 25 Nm (18 lb-ft).
12. Install the RH ignition coils.
13. Install the PCM bracket and the PCM.
14. Evacuate, leak test and charge the refrigerant system. For additional information, refer to Heating and Air Conditioning.
