F 150 4WD V8-5.4L Flex Fuel (2008)
12. Position the transmission cooler tube support bracket and install the nut.
^
Tighten to 10 Nm (89 lb-in).
13. NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
Using a new O-ring seal, install the RH CMP sensor and the bolt.
^
Tighten to 10 Nm (89 lb-in).
14. Connect the RH CMP sensor electrical connector.
15. Install the LH radio ignition interference capacitor and the nut.
^
Tighten to 10 Nm (89 lb-in).
16. NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
Using a new O-ring seal, install the LH CMP sensor and the bolt.
^
Tighten to 10 Nm (89 lb-in).
17. Connect the LH CMP sensor electrical connector.
18. Install the RH radio ignition interference capacitor and the nut.
^
Tighten to 10 Nm (89 lb-in).
19. Install the accessory drive belt tensioner and the 3 bolts.
^
Tighten to 25 Nm (18 lb-ft).
20. Install the coolant pump pulley and the 4 bolts.
^
Tighten to 25 Nm (18 lb-ft).
21. Install the 3 accessory drive idler pulleys and the 3 bolts.
^
Tighten to 25 Nm (18 lb-ft).
22. Lubricate the engine front cover and the crankshaft seal inner lip with clean engine oil.
23. Using the special tools, install a new crankshaft front seal into the engine front cover.
