F 150 4WD V8-5.4L Flex Fuel (2008)
Exhaust Manifold - LH
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the LH front and rear heated oxygen sensor (HO2S) electrical connectors.
3. Using the special tool, remove the 2 LH HO2S.
^
To install, tighten to 46 Nm (34 lb-ft).
4. Remove the 4 exhaust manifold-to-catalytic converter nuts.
^
To install, tighten to 40 Nm (30 lb-ft).
5. Remove the 2 bolts and disconnect the exhaust support bracket from the crossmember.
^
To install, tighten to 25 Nm (18 lb-ft).
6. Remove the LH dual converter Y-pipe assembly aside.
