F 150 4WD V8-5.4L Flex Fuel (2008)
3. NOTE:
-
One fuel level sender wire routes behind the fuel level sender and one routes along the left side of the fuel level sender.
-
The grounding eyelet must be on the front side of the fuel level sender.
Hook the fuel level sender on the fuel pump module and install the screw through the grounding eyelet and tighten the screw. Clip the wire into the
clip on the fuel pump module.
All vehicles
4. Slide the heat shrink tube onto the wire harness and connect the electrical connector.
5. WARNING: Do not use an open flame to shrink the heat shrink tube. Use a heat gun only. Fuel residue may be ignited if an open flame is
used. Failure to follow this instruction may result in serious personal injury.
Using a heat gun, heat the heat shrink tube.
