F 150 4WD V8-5.4L Flex Fuel (2008)
Transfer Case Actuator: Service and Repair
Transfer Case Shift Motor
1. With the ignition in the ON position, switch the mode select switch (MSS) to 4H.
2. Turn the ignition to the OFF position.
3. With the vehicle in NEUTRAL, position it on a hoist.
4. Disconnect the harness connector.
5. Remove the bracket bolt and the 3 mounting bolts, then remove the transfer case shift motor.
^
Remove the shifter shaft seal.
^
To install, tighten the bracket bolt to 10 Nm (89 lb-in) and tighten the 3 mounting bolts to 10 Nm (89 lb-in).
6. To install, reverse the removal procedure.
^
Apply a coat of multi-purpose grease to the transfer case shift motor mating surface.
