F 150 4WD V8-5.4L Flex Fuel (2008)
be restored to its original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt
assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard
passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the
risk of serious personal injury or death in a crash.
1. Remove the rear seat backrest.
2. Remove the nut and rear center and RH safety belt buckle assembly.
-
To install, tighten to 80 Nm (59 lb-ft).
3. NOTE: The LH safety belt buckle is attached to the rear center safety belt retractor assembly.
Remove the rear center safety belt retractor assembly.
4. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
5. Check the active restraint system for correct operation.
