F 150 4WD V8-5.4L Flex Fuel (2008)
-
Child safety seat tether bracket assemblies
-
Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)
If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and Testing portion, a new
safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be restored to its
original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt assemblies and
attaching hardware may increase the risk of serious personal injury or death in a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard
passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the
risk of serious personal injury or death in a crash.
1. Remove the rear seat backrest and cushion.
2. Open the D-ring cover.
3. Remove the outboard D-ring bolt.
-
To install, tighten to 48 Nm (35 lb-ft).
4. Remove the rear outboard safety belt anchor bolt.
-
To install, tighten to 48 Nm (35 lb-ft).
5. Remove the C-pillar trim panel(s) and position aside.
6. Remove the bolt and rear outboard safety belt retractor.
-
To install, tighten to 48 Nm (35 lb-ft).
7. To install, reverse the removal procedure.
8. Check the active restraint system for correct operation.
