F 150 4WD V8-5.4L Flex Fuel (2008)
9. Use a suitable tool to push the rubber grommet through the bulkhead.
10. From the passenger compartment, remove the selector lever cable from the vehicle.
Installation
All vehicles
1. From inside the vehicle, feed the selector lever cable through the opening in the bulkhead and downward toward the transmission.
2. Seat the selector lever cable rubber grommet in the bulkhead opening.
3. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever
cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the selector lever cable to click in place. Pull
back on the selector lever cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed
onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable end is correctly installed.
Connect the selector lever cable to the steering column.
1
Install the new selector lever cable retainer.
2
Connect the selector lever cable to the steering column bracket.
3
Connect the selector lever cable to the transmission selector lever arm and support.
4. Place the selector lever in the (D) position.
5. Hang a 1.4 kg (3 lb) weight on the selector lever.
6. Rotate the manual control lever forward until the travel stops. Then rotate the manual lever back 2 detents to the (D) position.
