ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

All Technical Service Bulletins for Torque Converter Clutch: > < A/T - Uncommanded TCC Lock Up On 1-2 Upshift
Page 2
background image

NOTE

THIS PROCEDURE IS PERFORMED IN 2ND GEAR AUTO (NOT MANUAL 2). MONITOR (TC SLIP ACT) AFTER THE POWERTRAIN
CONTROL MODULE (PCM) COMMANDS 2ND GEAR AND BEFORE THE VEHICLE SPEED SENSOR (VSS) READS 35 MPH (56 KM/H).

b. If you receive any other reading, this procedure does not apply; follow normal diagnostic procedures as outlined in the appropriate WSM.

NOTE

IT IS NORMAL FOR THE PCM TO COMMAND 4TH GEAR AT SPEEDS AS LOW AS 19 MPH (30 KM/H) WITH LIGHT ACCELERATION
WHEN THE THROTTLE POSITION IS LESS THEN 20%.

Parts Block

WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage 
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.

OPERATION

DESCRIPTION

TIME

092014A

2005-2010 Crown Victoria,

2.3 Hrs.

Grand Marquis, Town Car,
Econoline 150/250/350,
2005-2006 Expedition:
Includes Time To Perform
The Diagnosis Outlined In
This Article And Repair
(Do Not Use With Any
Other Labor Operations)

092014A

2005-2010 F-150,

2.2 Hrs.

2006-2008 Mark LT:
Includes Time To Perform
The Diagnosis Outlined In
This Article And Repair
(Do Not Use With Any
Other Labor Operations)

DEALER CODING

CONDITION

BASIC PART NO.

CODE

7E195

01

Disclaimer

All Technical Service Bulletins for Torque Converter Clutch: > < A/T - Uncommanded TCC Lock Up On 1-2 Upshift