F 150 4WD V8-5.4L Flex Fuel (2008)
6. Remove the driveshaft center bearing bolts and remove the driveshaft in the following sequence.
1
Remove the 2 driveshaft center bearing bolts.
2
Lower the driveshaft and slide the driveshaft slip yoke rearward off of the output shaft.
^
To install, tighten to 48 Nm (35 lb-ft).
7. Plug the extension housing to prevent fluid loss.
8. CAUTION: The driveshaft flange fits tightly on the pinion flange pilots. To make sure that the driveshaft flanges seat squarely on the
pinion flange pilots, tighten the driveshaft flange bolts evenly in a cross pattern or damage to the driveshaft flange can occur.
NOTE: If new bolts are not available, coat the threads of the original driveshaft flange bolts with threadlock and sealer.
NOTE: Align the index marks made during removal.
To install, reverse the removal procedure.
