F 150 4WD V8-54L VIN V Flex Fuel (2007) Seat Back Removal and Replacement
13. If equipped, disconnect the power seat track motor electrical connector and release any pin-type retainers attached to the seat cushion pan.
14. If equipped, disconnect the 3 memory seat motor position sensor (one shown) electrical connectors and release any pin-type retainers attached to
the seat cushion pan.
15. NOTE: Disconnect and release any remaining electrical connectors and pin-type retainers attached to the seat cushion and pan assembly.
Remove the 4 nuts and the seat cushion and pan assembly.
-
To install, tighten to 25 Nm (18 lb-ft).
16. NOTE: The lumbar adjuster must be removed to remove the backrest from the seat cushion assembly.
Remove the 2 screws and the recliner adjuster assembly.
