F 150 4WD V8-5.4L VIN V Flex Fuel (2007)
8. NOTE: Portions of the tailgate are removed for clarity.
Use a drift to press the broken end of the rod from the clamp block, then remove broken end through drain hole in the bottom edge of the tailgate.
9. Seal the 8 mm (0.31 in) access hole in the tailgate inner panel with silicone gasket and sealant.
10. Install the urethane bushing in the RH pivot.
Installation
1. NOTE: Portions of the tailgate are removed for clarity.
Install a new torsion rod through the LH pivot. Guide the rod into the clamp block.
2. Position the torsion rod so that the end bottoms out and is flush with the LH pivot.
