F 150 4WD V8-5.4L VIN V Flex Fuel (2007)
1. Inspect and clean both spring lock coupling ends. Install new O-ring seals and garter springs, if necessary.
-
Lubricate the O-ring seals with clean engine oil.
2. CAUTION: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the
tube.
Fit the male fitting into the female end and push until the garter spring snaps over the flared end of the female end.
3. Make sure the spring lock coupling is engaged by pulling on the lines.
4. Install the safety clip.
Disconnect - Type II
WARNING:
-
Do not smoke or carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly
