F 150 4WD V8-5.4L VIN V Flex Fuel (2007)
Throttle Position Sensor: Service and Repair
THROTTLE POSITION (TP) SENSOR
Removal
1. Disconnect the throttle position (TP) sensor electrical connector.
2. CAUTION: Failure to remove the TP sensor screws in the following manner will result in damage to the screws. First loosen the screws
1-2 full turns using a hand tool and then use a suitable high speed driver to complete the removal.
Remove and discard the 2 screws and the TP sensor.
Installation
1. CAUTION:
-
Do not reuse the TP sensor and screws. A new TP sensor and screws must be installed.
-
Do not use a high speed driver to install the new screws or damage to the TP sensor can occur.
NOTE: When installing the new TP sensor, make sure that the radial locator tab on the TP sensor is aligned with the radial locator hole on the
throttle body (TB).
Position the new TP sensor and install the 2 new screws.
-
Tighten to 3 Nm (27 lb-in).
2. Connect the TP sensor electrical connector.
