F 150 4WD V8-5.4L VIN V Flex Fuel (2007)
Engine Control Module: Service and Repair
Powertrain Control Module (PCM)
POWERTRAIN CONTROL MODULE (PCM)
Removal
1. NOTE: Any powertrain control module (PCM) replacement will require that ALL customer keys are available to be reprogrammed at the time of
installation. PCM replacement DOES NOT require new keys.
Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation procedure. See:
Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
2. Disconnect the PCM electrical connectors.
3. Remove the bolts and the PCM.
4. If necessary, remove the bolts and the PCM bracket.
Installation
1. If necessary, install the PCM bracket and the bolts.
-
Tighten to 10 Nm (89 lb-in).
2. Install the PCM and the bolts.
-
Tighten to 7 Nm (62 lb-in).
3. Connect the PCM electrical connectors.
4. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure.
5. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure.
