F 150 4WD V8-5.4L VIN V Flex Fuel (2007)
Child Seat Tether Attachment: Service and Repair
Child Safety Seat Tether Anchor - Latch, SuperCab and SuperCrew
CHILD SAFETY SEAT TETHER ANCHOR - LATCH, SUPERCAB AND SUPERCREW
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensor [BTS] if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
1. Remove the rear seat backrest and seat cushion.
2. Remove the 3 lower anchors and tethers for children (LATCH)-to-seat riser bolts and LATCH.
-
To install, tighten to 48 Nm (35 lb-ft).
3. To install, reverse the removal procedure.
