F 150 4WD V8-5.4L VIN V Flex Fuel (2007)
4. Install the driveshaft slip-yoke on the driveshaft.
1. Pull the slip-yoke boot toward the driveshaft. Lubricate the driveshaft splines with approximately 10 grams (0.24 oz) of TEK676 grease.
2. Position the new large slip-yoke boot clamp.
3. Align the blind splines, and install the driveshaft slip yoke on the driveshaft.
5. Set the driveshaft assembled length to specification.
1. Remove any excess grease from the slip-yoke boot and driveshaft slip-yoke surfaces.
2. Position the slip-yoke boot in the slip-yoke boot groove.
3. Set the driveshaft assembled length to specification.
^
Measure from the stub shaft weld to the U-joint centerline.
4. Bleed the air from the slip-yoke boot.
6. Using the special tool, crimp the large driveshaft slip-yoke boot clamp.
