F 150 4WD V8-5.4L VIN V Flex Fuel (2007)
4. Trim the remaining urethane adhesive on the pinch weld to within specification. The surface should be smooth, free of cuts and contamination.
5. CAUTION: Be sure to use the same brand and cure-rate products for the adhesive and primer. Do not mix different brands of urethane
and primer. Refer to the Material Chart in this procedure.
NOTE: Sika uses the same black primer for the glass and pinch weld area.
If installing a new windshield glass, apply urethane glass primer according to manufacturers instructions. Allow at least 6 minutes to dry.
6. Cut the urethane applicator tip to specification.
7. Apply a bead of urethane adhesive to the pinch weld just outside the foam dam.
8. Install the windshield by aligning it to the marks previously made.
9. After the windshield glass has set, check for water leaks and add urethane where needed.
10. Install the Y-clips.