F 150 4WD Pickup V8-281 4.6L VIN W EFI (1997)
NOTE: Note the orientation of the camber adjuster to make sure of the same camber setting.
5. Remove camber adjuster by hand or if difficulty is encountered use Pitman Arm Puller.
6. Place steering knuckle in vise and remove snap ring from bottom ball joint socket if so equipped.
7. Remove plug from U-Joint Tool and replace with Plug Tool (part of 4WD Ball Joint Tool Set).
8. Assemble U-Joint Tool and Receiving Cup (part of 4WD Ball Joint Tool Set).
NOTE: Always remove front suspension lower ball joint FIRST.
9. Turn forcing screw CLOCKWISE until front suspension lower ball joint is removed from steering knuckle.
10. Repeat procedure and remove front suspension upper ball joint.
Installation
1. Clean steering knuckle bore and insert front suspension lower ball joint as straight as possible.
